Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Tempe Junction, AZ

Richards-Wilcox Garage Door Roller Replacement in Tempe Junction, AZ

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. Typical cost $150-$350.

Our Richards-Wilcox garage door roller replacement service in Tempe Junction, AZ comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Worn steel or plastic rollers swapped for quiet, sealed nylon rollers. We work on Richards-Wilcox garage doors of every age, from older models to current lines, and carry or can source compatible parts.

When to call for Richards-Wilcox garage door roller replacement

  • Grinding, squealing or rumbling as the door moves
  • The door shakes or jerks in the track
  • Cracked, chipped or wobbly rollers
  • Rollers that no longer spin freely

Why this happens

  • Worn-out bearings in steel rollers
  • Cracked builder-grade plastic rollers
  • Rust or dust packed into the bearings

Before the technician arrives

  • Watch the rollers while the door moves. They should roll, not slide.
  • Look for cracked plastic wheels or wobbling stems.
  • Leave the bottom rollers to a technician. They sit in brackets that hold cable tension.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

What happens during the visit

  1. Inspect every roller, hinge and track section
  2. Replace rollers one hinge at a time, with sealed nylon rollers for a quieter door
  3. Replace the bottom rollers safely with tension controlled
  4. Lubricate hinges and bearings
  5. Test for smooth, quiet travel

How much does Richards-Wilcox garage door roller replacement cost?

$150-$350Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Richards-Wilcox services

Local Richards-Wilcox garage door roller replacement for Tempe Junction, AZ

Fine dust in Arizona packs into roller bearings and the track, so rollers start to drag and squeal well before they are worn out.

Our Richards-Wilcox garage door roller replacement service covers Tempe Junction (ZIP codes 85280, 85281 and 85287) and nearby towns including Tempe (2 mi), Guadalupe (3.2 mi), Mesa (7 mi) and Scottsdale (7 mi). Call (833) 435-8883 to book a visit in Tempe Junction.

Richards-Wilcox Garage Door Roller Replacement: frequently asked questions

How much does Richards-Wilcox garage door roller replacement cost in Tempe Junction, AZ?

Richards-Wilcox Garage Door Roller Replacement typically costs $150-$350 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Richards-Wilcox garage door roller replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Richards-Wilcox garage door roller replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Richards-Wilcox warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Arizona or Tempe Junction requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Tempe Junction, AZ

Wayne Dalton Off-Track Garage Door Repair

Wayne Dalton is part of the Overhead Door Corporation. Many Wayne Dalton doors use the TorqueMaster spring system, with the springs sealed inside the torsion tube, so spring work needs TorqueMaster parts and a different procedure.

Typical $175-$450

Garage Door Opener Repair

Openers that hum, click, reverse or won't respond, diagnosed and repaired.

Typical $125-$350

Richards-Wilcox Torsion Spring Replacement

Torsion springs replaced and wound correctly, with high-cycle upgrades available.

Typical $200-$450

Allstar Opener Gear & Sprocket Replacement

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $125-$275

Midland Garage Door Weather Seal Replacement

New bottom seals, threshold seals and perimeter stops to keep out water and drafts.

Typical $100-$300

Sommer Garage Door Sensor Repair

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $100-$250

Wall-Mount (Jackshaft) Opener Installation

Side-mounted openers that free up ceiling space and run quietly.

Typical $700-$1,400

Marantec Garage Door Sensor Repair

Marantec is a German manufacturer of residential and commercial door openers.

Typical $100-$250

Clopay Commercial Garage Door Repair

Repairs for commercial sectional, overhead and service doors.

Typical $250-$1,000

Marantec Remote & Keypad Programming

Marantec is a German manufacturer of residential and commercial door openers.

Typical $50-$150

Stanley Garage Door Opener Repair

Stanley garage door openers are no longer made. Compatible remotes and some parts are still available for older units.

Typical $125-$350

Amarr Garage Door Repair

Amarr, an ASSA ABLOY Group brand, makes residential lines such as Classica, Heritage, Lucern and Oak Summit, as well as commercial doors.

Typical $150-$450

Garage door stuck, noisy or broken?

Talk to a garage door technician in Tempe Junction, AZ now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote